Extreme Networks ExtremeWare - Enable Ip-Subnet-Lookup

enable ip-subnet-lookup
ExtremeWare Software 7.3.0 Command Reference Guide 899
enable ip-subnet-lookup
enable ip-subnet-lookup
Description
Enables IPDA SUBNET lookup feature in a switch.
Syntax Description
There are no arguments or variables for this command.
Default
Default is disabled.
Usage Guidelines
For a new setting to be effective, system rebooting is needed. If IPDA SUBNET lookup is enabled for
the first time, IPDA SUBNET lookup mask length is 24 (255.255.255.0).
Example
enable ip-subnet-lookup
To be effective, system rebooting is needed
# show ipc
IP Routing : Enabled
…..
MPLS : Disabled
IP-SUBNET-Lookup : Run-Time[Disabled: 0] Config[Enabled: 24]
In default status, IPDA SUBNET lookup feature is disabled.
# show ipc
IP Routing : Enabled
…..
MPLS : Disabled
IP-SUBNET-Lookup : Run-Time[Disabled: 0] Config[Disabled: 0]
If flow redirections, IPDA QOS, or FDB ACL is configured, operation is aborted with
error message
# enable ip-subnet-lookup
ERROR: Flow Redirection is already configured. Remove flow redirection configuration
at first.
History
This command was first available in ExtremeWare 7.3
Platform Availability
This command is available on all platforms.