2018 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
configure wireless ports interface ap-scan results timeout
configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
results timeout <time>
Description
This command sets the timeout threshold that sets when entries are aged out from the table.
Syntax Description
Default
300 seconds.
Usage Guidelines
Use this command to specify the age-out time for the clients in the results table.
Example
The following command configures port 1:7 and interface 1 to have a timeout threshold of 5 seconds:
configure wireless ports 1:7 interface 1 ap-scan results timeout 5
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
time Specifies the time in seconds before an entry is aged out of the results table.
Valid numbers are between 0 and n (any number).
To Next Page
Loading...
Need help?
General
