Extreme Networks ExtremeWare - Configure Debug-Trace Mpls-Signalling

configure debug-trace mpls-signalling
ExtremeWare Software 7.3.0 Command Reference Guide 2175
configure debug-trace mpls-signalling
configure debug-trace mpls-signalling <level>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 1.
Usage Guidelines
The debug level range is 1 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for MPLS signalling subsystem errors to 1:
configure debug-trace mpls-signalling 1
Following is the log output at this level:
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<INFO:SYST> User admin logged out from telnet (100.100.105.1)
<INFO:USER> admin logged in through telnet (100.100.105.1)
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> last message repeated 3 times
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
<DBUG:IPHS> Skipping FDB refresh for 10.3.1.1 due to LSP
debug level Specifies a debug level:
0 — None.
1 — Records peer interface state msgs.
2 — No additional information recorded.
3 — Records finite state machine events
4 — No additional information recorded.
5 — Records MPLS signalling packets, such as hello packets and label mappings.