Extreme Networks ExtremeWare - Configure Vlan Subvlan Address Range

configure vlan subvlan address range
ExtremeWare Software 7.3.0 Command Reference Guide 1179
configure vlan subvlan address range
configure vlan <vlan name> subvlan-address-range <ip address1> - <ip
address2>
Description
Configures sub-VLAN address ranges on each sub-VLAN to prohibit the entry of IP addresses from
hosts outside of the configured range.
Syntax Description
Default
N/A.
Usage Guidelines
There is no error checking to prevent the configuration of overlapping sub-VLAN address ranges
between multiple sub-VLANs. Doing so can result in unexpected behavior of ARP within the
super-VLAN and associated sub-VLANs.
Example
The following command configures the super-VLAN vsuper to prohibit the entry of IP addresses from
hosts outside of the configured range of IP addresses:
configure vlan vsuper subvlan-address-range 10.1.1.1 - 10.1.1.255
History
This command was available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all platforms.
vlan name Specifies a super-VLAN name.
ip address1 Specifies an IP address.
ip address2 Specifies another IP address.