configure wireless ports interface channel
ExtremeWare Software 7.3.0 Command Reference Guide 2021
configure wireless ports interface channel
configure wireless ports <portlist> interface [1 | 2] channel {0 |
<channel>}
Description
Configures a channel for the specified interface.
Syntax Description
Default
Auto for both interfaces.
Usage Guidelines
Each wireless port on the Alpine 3800 contains two interfaces. Interface 1 supports 802.11a, and interface
2 supports 802.11b/g radio signals. The
configure wireless port interface channel
command
allows you to configure one of the two individual interfaces (1|2) on a port or ports. You can move an
interface from one profile to another without having to shut it down.
Valid channel values are shown in Table 31.
Example
The following command configures a channel for interface 2 on port 5:
configure wireless port 5 interface 2 channel auto
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
interface Specifies an interface: 1 or 2.
0 Specifies that channels will be automatically selected. Enter ‘0’ (zero) to
specify auto selection.
channel Specifies a particular channel. (See Table 31 for valid values.)
Table 31: Valid wireless interface channel values
WLAN Standard Valid Channels
802.11a 0 (auto), 36, 40, 44, 48, 52, 56, 60, 64, 149, 153, 157,
161, 165, 169, (34, 38, 42, 46 for Japan)
802.11b and 802.11g 0 (auto), 1-14 (Must be valid entry for the country code
range; e.g., valid range for USA is 1-11.)
To Next Page
Loading...
Need help?
General
