1728 ExtremeWare Software 7.3.0 Command Reference Guide
T1, E1, and T3 WAN Commands
enable multilink
enable multilink <groupname>
Description
Enables an MLPPP multilink group
.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to enable a multilink group.
Example
The following command enables the multilink group ml_remote:
enable multilink ml_remote
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
groupname Specifies the multilink group name.
To Next Page
Loading...