900 ExtremeWare Software 7.3.0 Command Reference Guide
Security Commands
enable netlogin
enable netlogin [web-based | dot1x]
Description
Enables Network Login authentication modes.
Syntax Description
Default
Both types of authentication are enabled.
Usage Guidelines
Both types, either type, or no type of authentication can be enabled on the same switch. To disable an
authentication mode, use the following command:
disable netlogin [web-based | dot1x]
This command was first introduced as
enable netlogin
, which enabled the initial version of Network
Login, the web-based mode. The original command was subsequently deprecated when the 802.1x
mode of Network Login was introduced in ExtremeWare 7.1.0. The deprecated version of the command
is temporarily supported in configurations. During an upgrade, the deprecated command:
enable netlogin
will be interpreted as:
enable netlogin web-based
enable netlogin dot1x
Example
The following command enables web-based Network Login:
enable netlogin web-based
History
The
web-based
and
dot1x
keywords were added in ExtremeWare 7.1.0, and the initial version of the
command (without the new keywords) was deprecated.
This command was first available in ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
web-based Specifies web-based authentication.
dot1x Specifies 802.1x authenticating.
To Next Page
Loading...
Need help?
General
