232 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Configuring Slots and Ports on a Switch
configure msm-failover slave-config
configure msm-failover slave-config [inherited | flash]
Description
Configures the slave MSM-3 to inherit the software configuration from the master MSM-3.
Syntax Description
Default
Flash.
Usage Guidelines
If you enter the
flash
keyword, you cannot use the
preserve-state
option of the
configure
msm-failover link-action
command.
Example
The following command configures the slave MSM-3 to inherit the software configuration from the
current master MSM-3:
configure msm-failover slave-config inherited
History
This command was first available in ExtremeWare 7.1.1.
Platform Availability
This command is available on the BlackDiamond switch only.
inherited Specifies that the slave MSM-3 inherits the software configuration maintained
by the current master MSM-3 (this supports hitless failover).
flash Specifies that the slave MSM-3 use the configuration stored in its flash
memory (this is the default and does not support hitless failover).
To Next Page
Loading...