1042 ExtremeWare Software 7.3.0 Command Reference Guide
STP Commands
unconfigure stpd
unconfigure stpd {<spanning tree name>}
Description
Restores default STP values to a particular STPD or all STPDs.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to restore default STP values to a particular STPD. If you want to restore default STP
values on all STPDs, do not specify a spanning tree name.
For version 2.0:
• You can use the
all
parameter to specify all STPDs.
Example
The following command restores default values to an STPD named Backbone_st:
unconfigure stpd backbone_st
History
This command was first available in ExtremeWare 2.0.
Support for the
all
parameter was discontinued in ExtremeWare 7.0.
Platform Availability
This command is available on all platforms.
spanning tree name Specifies an STPD name on the switch.
To Next Page
Loading...