1220 ExtremeWare Software 7.3.0 Command Reference Guide
IP Unicast Commands
enable icmp useredirects
enable icmp useredirects
Description
Enables the modification of route table information when an ICMP redirect message is received.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
This option only applies to the switch when the switch is not in routing mode.
Example
The following command enables the modification of route table information:
enable icmp useredirects
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...