Extreme Networks ExtremeWare - Show Mpls Health-Check Mplsping

1830 ExtremeWare Software 7.3.0 Command Reference Guide
MPLS Commands
show mpls health-check mplsping
show mpls health-check mplsping {detail | <ipaddress> | prefix
<ipaddress/masklength> | <host_name> | lsp <lsp_name>}
Description
Displays the configuration and status for MPLS tunnel LSP health-checks.
Syntax Description
Default
N/A.
Usage Guidelines
This command displays the configuration and status for MPLS tunnel LSP health-checks. If no optional
keywords are specified, information is displayed in tabular format for all configured MPLS tunnel LSP
health-checks. Health-check information displayed includes the type of health-check, current status, and
relevant configuration parameters. If the optional
detail keyword is specified, the health-check
information is displayed in a comprehensive detail format. The detail format includes total state
transition count from up to down and down to up, time of last failure, total up time, and total down
time, and error code (if applicable). Optionally, an
ipaddress , ipaddress/masklength , host_name , or
lsp_name parameter can be specified to display specific mplsping information. This information is
always displayed in the detailed format.
Example
Needed
History
This command was first available in an ExtremeWare 7.3.
Platform Availability
This command is available on the BlackDiamond switch.
detail Displays the health-check information in comprehensive detail format.
ipaddress Display specific mplsping information for the specified address.
ipaddress/masklength Display specific mplsping information for the specified address.
host_name Display specific mplsping information for the specified host. Must be able to be
resolved to an IP address.
lsp_name Specifies the LSP to trace.