1696 ExtremeWare Software 7.3.0 Command Reference Guide
T1, E1, and T3 WAN Commands
configure multilink add
configure multilink <groupname> add ports <portlist>
Description
Adds ports to a multilink group.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to add ports to a previously created multilink group. All ports added to a multilink
group must be added as tagged ports. If the first port added to a multilink group is already configured
for PPP, the multilink group will inherit the configuration of the first port. Any other ports added to the
link will be configured to match the multilink configuration.
Only T1 or E1 ports can be added to multilink groups.
Example
The following command add ports the previously created multilink group “example_1”:
configure multilink example_1 add ports 2:1-2:4
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
groupname Specifies a previously created multilink group.
portlist A list of ports.
To Next Page
Loading...
Need help?
General
