506 ExtremeWare Software 7.3.0 Command Reference Guide
SLB Commands
configure slb vip
configure slb vip <vip name> unit [number]
Description
Configures the unit number for active-active failover.
Syntax Description
Default
The default unit is 1.
Usage Guidelines
You must first create the virtual server before you use this command. To create a virtual server, use the
following command:
create slb vip
Example
The following command configures the virtual server “test” with a unit number of 3:
configure slb vip test unit 3
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
vip name Specifies a virtual server.
unit Specifies a unit identifier on a virtual server. The range is 1 to 16.
To Next Page
Loading...