configure transceiver-test failure-action
ExtremeWare Software 7.3.0 Command Reference Guide 661
configure transceiver-test failure-action
configure transceiver-test failure-action [log | sys-health-check]
Description
Configures the action the switch takes if too many failures are detected within the specified window.
Syntax Description
Default
log.
Usage Guidelines
If you select
log
, only one instance of an error message is logged at this level.
If you select
sys-health-check
, and the switch detects too many failures, the switch takes the
configured system health check action. To configure the system health check, use the
configure
sys-health-check [alarm-level [card-down | default | log | system-down | traps] |
auto-recovery <number of tries>]
command.
The alarm-level and auto-recovery options are mutually exclusive; configuring an alarm-level disables
auto-recovery, and configuring auto-recovery overrides the alarm-level setting.
By default, the switch checks for errors within the last eight 20-second windows. Use the
configure
transceiver-test window
command to modify the number of windows.
To determine if you have the transceiver test enabled and the failure action the switch takes, use the
show switch
command. The following is sample transceiver test output:
Transceiver Diag: Enabled. Failure action: log only
For ExtremeWare 6.2.2b108:
The default is
sys-health-check
, and the switch takes the configured system health check action.
Example
The following command configures the switch to perform the configured system health check action if
too many failures are detected:
configure transceiver-test failure-action sys-health-check
History
This command was first available in ExtremeWare 6.2.2b108.
The default for this command was changed to
log
in ExtremeWare 6.2.2b134.
log Specifies that messages are sent to the syslog.
sys-health-check Specifies the configured system health check action is taken.
To Next Page
Loading...