configure wireless ports interface client-history size
ExtremeWare Software 7.3.0 Command Reference Guide 2023
configure wireless ports interface client-history size
configure wireless ports [<portlist> | all] interface [1 | 2]
client-history size <integer>
Description
Use this command to configure the client history size.
Syntax Description
Default
128.
Usage Guidelines
None.
Example
The following example sets the client-history table for ports 1:1-1:20 and interface 2 to 100 entries:
configure wireless ports 1:1-1:30 interface 2 client-history size 100
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
integer Specifies the size of the client-history table in terms of the number of entries.
Valid values are between 1 and 128 entries.
To Next Page
Loading...
Need help?
General
