1634 ExtremeWare Software 7.3.0 Command Reference Guide
PoS Commands
configure aps lockout
configure aps <group#> lockout [off | on]
Description
Controls whether a switch to the protection line is locked out.
Syntax Description
Default
The default is
off
.
Usage Guidelines
The
group#
identifies the APS group that the
lockout
command applies to. When
lockout on
is
specified, switches from the working line to the protection line are prohibited, until you subsequently
issue a
lockout off
command. The default is lockout off. This command is only applicable to SONET
ports performing the protection line function. Additionally, the effects of this command are not
preserved across a switch reboot.
Example
The following command example turns on lockout mode for APS group
1001
:
config aps 1001 lockout on
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
group# Specifies the APS group# to which the command applies.
off Specifies that switches from the working line to the protection line are allowed.
on Specifies that switches from the working line to the protection line are
prohibited.
To Next Page
Loading...
Need help?
General
