configure vlan add ports restart
ExtremeWare Software 7.3.0 Command Reference Guide 1069
configure vlan add ports restart
configure vlan <vlan name> add ports [<portlist> | all] restart
Description
Configures ESRP to restart ports if there is a state change and the downstream switch is from another
vendor.
Syntax Description
Default
N/A.
Usage Guidelines
If a VLAN becomes a slave, ESRP disconnects member ports that have port restart enabled. The
disconnection of these ports causes downstream devices to remove the ports from their FDB tables.
After 3 seconds the ports re-establish connection with the ESRP-enabled device. This feature allows you
to use ESRP in networks that include equipment from other vendors.
Example
The following command enables port restart for ports 7-9 on VLAN esrp1:
configure vlan esrp1 add ports 7-9 restart
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
vlan name Specifies an ESRP-enabled VLAN name.
portlist Specifies list of ports or slots and ports. May be in the form 1, 2, 3-5, 2:*, 2:5,
2:6-2:8.
all Specifies all ports.
To Next Page
Loading...
Need help?
General
