Extreme Networks ExtremeWare - Configure Ipxroute Add

configure ipxroute add
ExtremeWare Software 7.3.0 Command Reference Guide 1567
configure ipxroute add
configure ipxroute add [<dest_netid> | default] <next_hop_id>
<next_hop_node_addr> <hops> <tics>
Description
Adds a static IPX route entry in the IPX route table.
Syntax Description
Default
N/A.
Usage Guidelines
Static routes are used to reach networks not advertised by routers. You can configure up to 64 static IPX
routes on the switch. Static routes are never aged out of the routing table. Static routes are advertised to
the network using IPX/RIP.
Example
The following command adds a static IPX route entry to the IPX route table:
configure ipxroute add default 0011 00:eb:2a:0b:1e:0a
History
This command was introduced in ExtremeWare 4.0.
Platform Availability
This command is available on the all “i” series systems.
dest_netid Specifies the destination NetID.
next_hop_id Specifies the NetID of the neighbor IPX network.
next_hop_node_addr Specifies the node address of the next IPX router.
hops Specifies the maximum hop count.
tics Specifies the timer delay value.