1622 ExtremeWare Software 7.3.0 Command Reference Guide
ATM Commands
configure atm scrambling
configure atm scrambling [on | off] ports <portlist>
Description
This command configures an ATM port to scramble the cell payload on a specified ATM port(s).
Syntax Description
Default
Enabled.
Usage Guidelines
Scrambling is used to improve signal synchronization and the performance of the ATM cell delineation
process.
Choose either
on
or
off
. Scrambling is enabled by default.
Example
The following command example turns off the scrambling function for port 1 of the ATM module
installed in slot 8 of a BlackDiamond switch.
configure atm scrambling off ports 8:1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the BlackDiamond switch only.
on Enables payload data scrambling. Default is on.
off Disables payload data scrambling.
portlist Specifies list of ports or slots and ports. May be in the form 2:5, 2:6-2:8.
To Next Page
Loading...
Need help?
General
