Extreme Networks ExtremeWare - Disable Flowstats Filter Ports

670 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
disable flowstats filter ports
disable flowstats filter <filter#> ports <portlist> {ingress | egress}
Description
Disables a specified flow record filter for the specified ports.
Syntax Description
Default
For the PoS module, filter #1 is enabled on all SONET ports, and the remaining filters are disabled.
For other switches or modules, filters are enabled by default when they are configured.
Usage Guidelines
The filter # parameter is an integer in the range [1-8].
For each SONET port on a PoS module, sixteen filters are supported—eight filters for ingress flows and
another eight filters for egress flows. The
filter # parameter and either the ingress or egress
keyword are used to identify the particular filter that is being disabled.
One of either the ingress or egress keywords are required for SONET ports.
Example
The following command disables filter 3 for ports 1-8 on an “i” series switch:
disable flowstats filter 3 ports 1-8
The following command example disables ingress filter #2 on port 1 of the PoS module installed in slot
8 of the BlackDiamond switch:
disable flowstats filter 2 ports 8:1 ingress
History
This command was first available in ExtremeWare 6.1.5b20 for the PoS module only.
This command was first available in ExtremeWare 6.2 for all “i” series platforms.
filter# Specifies the flow record filter that should be disabled.
portlist Specifies a list of ports or slots and ports for which the filter should be
disabled. May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
ingress Use this keyword to specify that the filter being enabled or disabled is one of
the eight filters to be applied to inbound flows. Supported on the PoS module
only.
egress Use this keyword to specify that the filter being enabled or disabled is one of
the eight filters to be applied to outbound flows. Supported on the PoS module
only.