Extreme Networks ExtremeWare - Configure Wireless Ports Interface Transmit-Rate

configure wireless ports interface transmit-rate
ExtremeWare Software 7.3.0 Command Reference Guide 2033
configure wireless ports interface transmit-rate
configure wireless ports <portlist> interface [1 | 2] transmit-rate <rate>
Description
Configures a transmission rate for the specified port.
Syntax Description
Default
54 Mbps.
Usage Guidelines
Each wireless port on the Alpine 3800 contains two interfaces. Interface 1 supports 802.11a, and interface
2 supports 802.11b/g radio signals. The
configure wireless port interface transmit-level
command allows you to configure the transmission rate for one of the two individual interfaces (1|2) on
a port or ports.
Valid transmission rate values are shown in Table 32.
Example
The following command configures the port 14 to transmit at 54 Mbps for both interface 1 and 2 (A and
G):
configure wireless port 14 interface 1 transmit-rate 54
configure wireless port 14 interface 2 transmit-rate 54
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
interface Specifies an interface: 1 or 2.
rate Specifies the transmission rate for the port. Entering auto specifies automatic
transmission rate selection. Valid values are shown in
Table 32.
Table 32: Valid transmission rate values
Mode Valid Transmission Rate
A 6, 9, 12, 18, 24, 36, 48, 54, auto
B 1, 2, 5.5, 11, auto
G 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54, auto