configure debug-trace isis-lsp
ExtremeWare Software 7.3.0 Command Reference Guide 2169
configure debug-trace isis-lsp
configure debug-trace isis-lsp <level>
Description
Controls logging of debug messages related to sending and receiving and decoding and encoding of
LSP Messages.
Syntax Description
Default
The default is 0.
Usage Guidelines
The
debug level
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
History
This command was first available in ExtremeWare v6.1.8 IS-IS tech release and subsequently
incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level. Following are the debug levels:
0 — Critical/Error Messages
1 — Warning Messages
2 — Concise Messages
3 — Verbose Messages
4 — Packet Dumps
To Next Page
Loading...