Extreme Networks ExtremeWare - Enable Rip Originate-Default Cost

enable rip originate-default cost
ExtremeWare Software 7.3.0 Command Reference Guide 1373
enable rip originate-default cost
enable rip originate-default {always} cost <number> {tag <number>}
Description
Configures a default route to be advertised by RIP if no other default route is advertised.
Syntax Description
Default
Disabled.
Usage Guidelines
If always is specified, RIP always advertises the default route to its neighbors. If always is not specified,
RIP adds a default route if a reachable default route is not in the route table.
The cost metric is inserted for all RIP-learned, static, and direct routes injected into OSPF. If the cost
metric is set to 0, the cost is inserted from the route. The tag value is used only by special routing
applications. Use 0 if you do not have specific requirements for using a tag.
Example
The following command configures a default route to be advertised by RIP if no other default route is
advertised:
enable rip originate-default cost 0
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
always Specifies to always advertise the default route.
cost <number> Specifies a cost metric.
tag <number> Specifies a tag number.