Extreme Networks ExtremeWare - Enable Wireless Ports Interface Ap-Scan

enable wireless ports interface ap-scan
ExtremeWare Software 7.3.0 Command Reference Guide 2055
enable wireless ports interface ap-scan
enable wireless ports <portlist> interface [1 |2] ap-scan
Description
Starts a wireless port on-channel scan for the indicated port or ports and interface for the Altitude 300.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to start the wireless port on-channel scan on the indicated port and interface for the
Altitude
300. The Altitude 300 continues to carry user traffic during scans operating on the current
channel (“on-channel” scans).
Example
The following command enables interface 2 on ports 1:18 to 1:28:
enable wireless ports 1:18-1:28 interface 2 ap-scan
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
interface Specifies an interface: 1 or 2.