Extreme Networks ExtremeWare - Show Slb Global

show slb global
ExtremeWare Software 7.3.0 Command Reference Guide 585
show slb global
show slb global
Description
Displays the current SLB global configuration information.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
Displays the following:
• Global enable/disable mode
• Global modes
• Default settings for health checker
• Failover configuration
Example
The following command displays the current SLB global configuration information:
show slb global
Following is the output from this command:
SLB: Enabled
SynGuard: Disabled
3DNS IQuery Support Status: Disabled
SLB persist-level: same-vip-same-port
SLB persistence-method: per-session
SLB pre-allocated connection-block size: 10000
SLB connection timeout: 1
SLB persistence on client proxies: Disabled
Proxy Client Persistence entries:
No. of Proxy Client Persistence entries: 0
#
#
Health Check Defaults:
Ping-check Frequency: 10 Timeout: 30
Port-check Frequency: 30 Timeout: 90
Service-check Frequency: 60 Timeout: 180
HTTPURL: "/"
Match String: (any-content)
FTP User: anonymous
Password: (not shown)
TelnetUser: anonymous