Extreme Networks ExtremeWare - Configure Stpd Priority

configure stpd priority
ExtremeWare Software 7.3.0 Command Reference Guide 1019
configure stpd priority
configure stpd <spanning tree name> priority <priority>
Description
Specifies the bridge priority of the STPD.
Syntax Description
Default
32,768.
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
By changing the priority of the STPD, you can make it more or less likely to become the root bridge.
The range for the priority parameter is 0 through 65,535. A setting of 0 indicates the highest priority.
Example
The following command sets the bridge priority of STPD1 to 16,384:
configure stpd stpd1 priority 16384
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
spanning tree name Specifies an STPD name on the switch.
priority Specifies the bridge priority of the STPD.