402 ExtremeWare Software 7.3.0 Command Reference Guide
QoS Commands
enable diffserv replacement ports
enable diffserv replacement ports [<portlist> | all]
Description
Enables the diffserv code point to be overwritten in packets transmitted by the switch.
Syntax Description
Default
Disabled.
Usage Guidelines
Eight user-defined code points can be configured on each port. The 802.1P priority bits (3-bits) are used
to select one of the eight code points.
Example
The following command enables Diffserv replacement on selected ports:
enable diffserv replacement ports 3,5,6
History
This command was available in ExtremeWare 6.0.
Platform Availability
This command is available on all platforms.
portlist Specifies a list of ports or slots and ports to which the parameters apply. May
be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
all Specifies that Diffserv replacement should be enabled for all ports.
To Next Page
Loading...