1260 ExtremeWare Software 7.3.0 Command Reference Guide
IGP Commands
clear isis lsdb
clear isis lsdb {level-2 | area <isis area identifier>} {system-identifier
<system identifier> | sysName <alphanumeric string>} {type [non-pseudonode
| pseudonode {circuit-identifier <number(1-255)>}]} {lsp-number
<number(0-255)>}
Description
Clears the IS-IS LSDB of the level 2 subdomain or a level 1 area.
Syntax Description
Default
N/A.
Usage Guidelines
This command clears the IS-IS LSDB for the level 2 subdomain or a level 1 area. If no parameters are
specified, all entries are cleared.
Example
The following command clears all non-pseudonode LSDB:
clear isis lsdb type non-pseudonode
History
This command was first available in ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
level-2 Specifies the level 2 subdomain.
isis area identifier Specifies a level 1 area identifier.
system identifier Specifies a system identifier. The format is xxxx.xxxx.xxxx, where x is a
hexadecimal digit.
alphanumeric string Specifies the system name of the switch.
type Specifies LSDB type, non-pseudonode or pseudonode.
number(1-255) Specifies a circuit ID from 1 to 255.
number(0-255) Specifies an LSP number from 0 to 255.
To Next Page
Loading...