430 ExtremeWare Software 7.3.0 Command Reference Guide
NAT Commands
configure nat timeout
configure nat timeout <seconds>
Description
Configures the timeout for any IP packet that is not TCP, UDP, or ICMP.
Syntax Description
Default
Default timeout is 600 seconds.
Usage Guidelines
Setting the timeout to zero specifies that session table entries should not be timed-out. This is not
normally recommended as NAT resources will get used up.
Example
The following command configures the timeout for packets other than TCP, UDP, or ICMP to 240
seconds:
configure nat timeout 240
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
seconds Specifies the number of seconds to wait before the session table entry times
out.
To Next Page
Loading...