Extreme Networks ExtremeWare - Disable Wireless Ports Interface Iapp

disable wireless ports interface iapp
ExtremeWare Software 7.3.0 Command Reference Guide 2049
disable wireless ports interface iapp
disable wireless ports [<portlist> | all] interface [1 | 2] iapp
Description
Disables Inter-Access Point Protocol (IAPP) on a per interface basis.
Syntax Description
Default
Enabled.
Usage Guidelines
Use this command to disable IAPP for the selected ports and interface. IAPP uses layer 2 updates to
allow connected layer 2 devices to update forwarding tables with the address of the client. The access
point (AP) sends the updates on behalf of the clients by inserting the MAC address of the mobile station
in the source address. The switch looks up the UDP request packet on the local subnet that contains the
AP’s MAC address which contains the needed IP address. All APs on the subnet receive this message.
The AP with the matching MAC address sends a unicast response packet with its IP address.
Example
The following example disables port 1:15 and interface 1 for IAPP:
disable wireless ports 1:15 interface 1 iapp
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.