configure slb failover dead-frequency
ExtremeWare Software 7.3.0 Command Reference Guide 455
configure slb failover dead-frequency
configure slb failover dead-frequency <seconds>
Description
Configures the frequency at which the local switch attempts to re-establish communication with the
unresponsive remote switch.
Syntax Description
Default
The default dead frequency is 2 seconds.
Usage Guidelines
To enable active-active operation, use the following command:
enable slb failover
Example
The following command sets the dead frequency to 5 seconds:
configure slb dead-frequency 5
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
dead-frequency The frequency at which the local switch attempts to re-establish
communication with the unresponsive remote switch. The range is 1 to 60.
To Next Page
Loading...