Extreme Networks ExtremeWare - Configure Mpls Ldp Advertise Vlan

configure mpls ldp advertise vlan
ExtremeWare Software 7.3.0 Command Reference Guide 1781
configure mpls ldp advertise vlan
configure mpls ldp advertise [add | delete] vlan <vlan name>
Description
Configures LDP to originate an unsolicited label for the FECs associated with the directly attached
routing interface of the specified VLAN.
Syntax Description
Default
N/A.
Usage Guidelines
Configures LDP to originate an unsolicited label for the FECs associated with the directly attached
routing interface of the specified VLAN. The
delete keyword removes label origination of the direct
route for the specified VLAN. The LDP label origination configuration for directly attached routing
interfaces can also be set using the
configure mpls ldp advertise direct command.
Example
The following command configures LDP to advertise a label for the direct route configured for VLAN
vlan1:
configure mpls advertise add vlan vlan1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the BlackDiamond switch only.
add Originates an unsolicited label for the FECs associated with the directly
attached routing interface of the specified VLAN
delete Removes label origination of the direct route for the specified VLAN
vlan name Specifies the name of the VLAN.