1344 ExtremeWare Software 7.3.0 Command Reference Guide
IGP Commands
disable rip exportstatic
disable rip exportstatic
Description
Disables the redistribution of static routes.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
Static routes are manually entered into the routing table. Static routes are used to reach networks not
advertised by routers. You can configure 64 static unicast routes. Static routes can also be used for
security reasons, to control which routes you want advertised by the router. You can decide if you want
all static routes to be advertised. Static routes are never aged out of the routing table.
A static route must be associated with a valid IP subnet. An IP subnet is associated with a single VLAN
by its IP address and subnet mask. If the VLAN is subsequently deleted, the static route entries using
that subnet must be deleted manually.
Example
The following command disables the redistribution of static routes:
disable rip exportstatic
History
This command was removed in ExtremeWare 6.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...
Need help?
General
