2024 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
configure wireless ports interface client-history timeout
configure wireless ports [<portlist> | all] interface [1 | 2]
client-history timeout <number>
Description
Use this command to configure the client history timeout interval.
Syntax Description
Default
600 seconds.
Usage Guidelines
Use this command to specify the timeout interval for the clients in the client history table.
Example
The following example sets the timeout interval for the client-history table for ports 1:1-1:20 and
interface 2 to 100 seconds.
configure wireless ports 1:1-1:20 interface 2 client-history timeout 100
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
number Specifies the timeout interval of the client-history table in seconds. Valid
numbers are between 0 and n (any number).
To Next Page
Loading...