configure snmp sysLocation
ExtremeWare Software 7.3.0 Command Reference Guide 123
configure snmp sysLocation
configure snmp syslocation <alphanumeric string>
Description
Configures the location of the switch.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to indicate the location of the switch. A maximum of 255 characters is allowed.
To view the location of the switch on the switch, use the
show switch
command. The
show switch
command displays switch statistics including the location of the switch.
To restore defaults to all SNMP-related entries, including the SNMP parameters modified using the
configure snmp syslocation <alphanumeric string>
command, use the
unconfigure
management
command.
Example
The following command configures a switch location name on the system:
configure snmp syslocation englab
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
alphanumeric string Specifies the switch location.
To Next Page
Loading...