configure debug-trace flow-redirect
ExtremeWare Software 7.3.0 Command Reference Guide 2151
configure debug-trace flow-redirect
configure debug-trace flow-redirect <debug level>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The
debug level
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for flow redirect errors to 2:
configure debug-trace flow-redirect 2
Following is the log output at this level:
<INFO:IPRT> redirect next hop http1 30.0.0.9 changed to up
<DBUG:SYST> i=1 Changing Nexthop fg=fffc Source=24.3.89.150 Nexthop=30.0.0.6 Nfg=fffb
<DBUG:SYST> i=0 Changing Nexthop fg=fffc Source=24.3.89.149 Nexthop=30.0.0.5 Nfg=fffa
<DBUG:SYST> i=4 Changing Nexthop fg=fffc Source=24.3.89.148 Nexthop=30.0.0.9 Nfg=ffff
<DBUG:SYST> i=3 Changing Nexthop fg=fffc Source=24.3.89.147 Nexthop=30.0.0.8 Nfg=fffe
<DBUG:SYST> i=2 Changing Nexthop fg=fffc Source=24.3.89.146 Nexthop=30.0.0.7 Nfg=fffd
<DBUG:SYST> i=1 Changing Nexthop fg=fffc Source=24.3.89.145 Nexthop=30.0.0.6 Nfg=fffb
<DBUG:SYST> i=0 Changing Nexthop fg=fffc Source=24.3.89.144 Nexthop=30.0.0.5 Nfg=fffa
<DBUG:SYST> Sag=fffc
<DBUG:SYST> Grps0 = fffa fffb fffd fffe ffff 0 0 0
<DBUG:SYST> rLBS inst=0 inUse=1 SA=24.3.89.144 sMask=fffffff 8 dPort=50
<DBUG:SYST> Looking for entries to balance in redirect 3
<DBUG:SYST> Looking for entries to balance in redirect 2
<DBUG:SYST> Looking for entries to balance in redirect 1
<DBUG:SYST> Looking for entries to balance in redirect 0
<INFO:IPRT> redirect next hop http1 30.0.0.8 changed to up <DBUG:SYST> Balancing group
ffff
debug level Specifies a debug level:
0 — None.
1 — Records configuration changes and unexpected code states.
2 — Records next-hop resources becoming active or inactive.
3 — No additional information recorded.
4 — No additional information recorded.
5 — No additional information recorded.