2014 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
configure wireless ports interface ap-scan off-channel
min-wait
configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
off-channel min-wait <num>
Description
Use this command to set the minimum time an off-channel scan waits at a particular channel.
Syntax Description
Default
60 ms.
Usage Guidelines
Use this command to specify the minimum time that the access point (AP) should scan a particular
channel.
Example
The following command sets the wait time at 5 milliseconds:
configure wireless ports 1:5 interface 2 ap-scan off-channel min-wait 5
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
num Specifies the minimum wait time in milliseconds. Valid entries are between 10
and 10000 milliseconds.
To Next Page
Loading...
Need help?
General
