2078 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
show wireless ports interface ap-scan status
show wireless ports [<portlist> | all] interface [1 | 2] ap-scan status
Description
Displays the status of the access point (AP) scan for the port and the interface.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to check the AP scan status on a particular port and interface.
Examples
The following command shows the status of the AP scan for the port and interface:
show wireless port 1:5 interface 1 ap-scan status
The output of the command is similar to the following:
Intf Enabled Num-Probes Num-APs WaterMark TimeOuts Overflows OCS
-------------------------------------------------------------------------------
1:1 N 0 0 0 0 0 N
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
To Next Page
Loading...
Need help?
General
