314 ExtremeWare Software 7.3.0 Command Reference Guide
VLAN Commands
configure dot1q ethertype
configure dot1q ethertype <ethertype>
Description
Configures an IEEE 802.1Q Ethertype.
Syntax Description
Default
Ethertype value of 8100.
Usage Guidelines
Use this command if you need to communicate with a switch that supports 802.1Q, but uses an
Ethertype value other than 8100. This feature is useful for VMAN tunneling. Extreme Networks
recommends the use of IEEE registered ethertype 0x88a8 for deploying vMANs.
Extreme switches assume an Ethertype value of 8100.
You must reboot the switch for this command to take effect.
Example
The following command, followed by a switch reboot, changes the Ethertype value to 9100:
configure dot1q ethertype 88a8
History
This command was first available in ExtremeWare 1.0.
Platform Availability
This command is available on all platforms.
ethertype Specifies an Ethertype value.
To Next Page
Loading...
Need help?
General
