Extreme Networks ExtremeWare User Manual

enable aps
ExtremeWare Software 7.3.0 Command Reference Guide 1679
enable aps
enable aps
Description
Enables the APS function for an entire switch.
Syntax Description
This command has no arguments or variables.
Default
APS is disabled by default.
Usage Guidelines
If APS is enabled, interfaces configured as protection lines can carry traffic.
Example
To enable the APS function for the entire switch, use the following command:
enable aps
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.

Extreme Networks ExtremeWare Specifications

General

Brand	Extreme Networks
Model	ExtremeWare
Category	Software
Language	English