2012 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
configure wireless ports interface ap-scan off-channel
configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
off-channel [add | del] {current-channel | all-channels | every-channel}
Description
Adds or removes specific channels for the off-channel access point (AP) scan.
Syntax Description
Default
All channels.
Usage Guidelines
Use this command when the AP scan must be started on a particular interface.
Example
The following command causes scans on the current channel for wireless port 1:5 using interface 2:
configure wireless ports 1:5 interface 2 add current channel
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
add Specifies to add the specific channel.
del Specifies to delete the specific channel.
current-channel Specifies to perform the scan on the current channel only.
all-channels Specifies to perform the scan on all channels in a given country code.
every-channel Specifies to perform the scan on all channels regardless of the country code.
No beacons are sent on out-of-country-code channels.
To Next Page
Loading...
Need help?
General
