1442 ExtremeWare Software 7.3.0 Command Reference Guide
BGP Commands
configure bgp peer-group timer
configure bgp peer-group <peer group> timer keep-alive <seconds> hold-time
<seconds>
Description
Configures the keepalive timer and hold timer values for a peer group and all the neighbors of the peer
group.
Syntax Description
Default
N/A.
Usage Guidelines
Changes made to the parameters of a peer group are applied to all neighbors in the peer group.
Modifying the following parameters automatically disables and enables the neighbors before changes
take effect:
• remote-as
• timer
• source-interface
• soft-in-reset
• password
Example
The following command configures the keepalive timer and hold timer values for the peer group outer
and its neighbors:
configure bgp peer-group outer timer keep-alive 30 hold-time 90
History
This command was available in ExtremeWare 6.1.5.
Platform Availability
This command is available on all platforms.
peer group Specifies a peer group.
keep-alive <seconds> Specifies a keepalive time in seconds.
hold-time <seconds> Specifies a hold-time in seconds.
To Next Page
Loading...