2098 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
show wireless ports interface rf-status
show wireless ports [<portlist> | all] interface [1 | 2] rf-status {detail}
Description
Displays data rates for the selected port and interface.
Syntax Description
Default
N/A.
Usage Guidelines
Each wireless port on the Alpine 3800 contains two interfaces. Interface 1 supports 802.11a, and interface
2 supports 802.11b/g radio signals. The
show wireless port interface rf-status
command
allows you to display information about one of the two individual interfaces (1|2) on a port or ports.
Examples
The following example displays rf-status of all active ports of the switch:
show wireless ports all interface 1 rf-status
The output of the command is similar to:
Port Intf Tx Rate Channel Noise Floor
--------------------------------------------------------------
1:37 1 54 64 85
1:38 1 54 64 84
The following example displays detailed rf-status of all active ports of the switch:
show wireless ports all interface 1 rf-status detail
The output of the command is similar to:
Wireless Interface: 1:37:1
Transmit Rate: 54
Beacon Interval: 40
DTIM: 2
Preamble: Short
Long Retry: 7
Short Retry: 4
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
detail Specifies to display the information in detailed format.
To Next Page
Loading...