832 ExtremeWare Software 7.3.0 Command Reference Guide
Security Commands
configure tacacs server
configure tacacs [primary | secondary] server [<ipaddress> | <hostname>]
{<tcp_port> | <L4 port no>} client-ip <ipaddress>
Description
Configures the server information for a TACACS+ authentication server.
Syntax Description
Default
TACACS+ uses TCP port 49.
Usage Guidelines
Configure the server information for a TACACS+ server.
To remove a server, use the following command:
unconfigure tacacs server [primary | secondary]
Use of the <hostname> parameter requires that DNS be enabled.
Example
The following command configures server tacacs1 as the primary TACACS+ server for client switch
10.10.20.35:
configure tacacs primary server tacacs1 client-ip 10.10.20.35
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
primary Configures the primary TACACS+ server.
secondary Configures the secondary TACACS+ server.
ipaddress Specifies the IP address of the TACACS+ server being configured.
hostname Specifies the host name of the TACACS+ server being configured. Must be
able to be resolved to an IP address.
tcp_port Specifies the TCP port to use to contact the TACACS+ server.
L4 port no Specifies the L4 port used to contact the TACACS+ server.
ipaddress The IP address used by the switch to identify itself when communicating with
the TACACS+ server.
To Next Page
Loading...
Need help?
General
