Extreme Networks ExtremeWare - Show Log Configuration

show log configuration
ExtremeWare Software 7.3.0 Command Reference Guide 719
show log configuration
show log configuration
Description
Displays the log configuration for switch log settings, and for certain targets.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
This command displays the log configuration for all targets. The state of the target, enabled or disabled
is displayed. For the enabled targets, the associated filter, severity, match expression, and format is
displayed. The debug mode state of the switch is also displayed.
Example
The following command displays the configuration of all the log targets:
show log configuration
The output produced by the command is similar to the following:
Severities: Critical, Error, Warning, Notice, Info, Debug-Summary, Debug-Verbose,
Debug-Data
Log Target : session 1028 (10.38.0.42)
Enabled : no
Filter Name : DefaultFilter
Severity : info (through critical)
Match : (none)
Format : MM/DD/YYYY HH:MM:SS.hh <Severity:Component.SubComponent.Conditi
on>
Log Target : console-display
Enabled : no
Filter Name : DefaultFilter
Severity : info (through critical)
Match : (none)
Format : MM/DD/YYYY HH:MM:SS.hh <Severity:Component.SubComponent.Conditi
on>
Remote syslog targets are disabled by default.
Debug-Mode is disabled.
History
This command was first available in ExtremeWare 2.0.