Extreme Networks ExtremeWare - Configure Debug-Trace Vrrp-Hello

2198 ExtremeWare Software 7.3.0 Command Reference Guide
Troubleshooting Commands
configure debug-trace vrrp-hello
configure debug-trace vrrp-hello <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The debug level range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for VRRP hello messages to 4:
configure debug-trace vrrp-hello 4
Following is the log output at this level:
<DBUG:SYS > Vlan=Default: vrrpTransmit: vrid=1,pri=255,cnt_ip_addr=1,auth_type=0
advert=1,ipaddr=10.45.208.10
<DBUG:SYS > Vlan=Default: vrrpTransmit: vrid=1,pri=255,cnt_ip_addr=1,auth_type=0
advert=1,ipaddr=10.45.208.10
<DBUG:SYS > Sending vrrp-pkt(0x8313d630) len 40 to 224.0.0.18 if rif0,
mac=00:00:5e:00:01:01
<DBUG:KERN> <--- Start of chain (84859200) --->
<DBUG:KERN> m0 @ 0x84859200: Length=40 m_off=20 m_data=0x84859214
<DBUG:KERN> 0x0884859214: 00 00 00 28 00 00 00 00 ff 70 00 00 00 00 00 00
***(*****p******
<DBUG:KERN> 0x0884859224: e0 00 00 12 21 01 ff 01 00 01 05 c4 0a 2d d0 0a
****!********-**
<DBUG:KERN> 0x0884859234: 00 00 00 00 00 00 00 00 ********
<DBUG:KERN> <--- End of chain (84859200) --->
debug level Specifies a debug level:
0 — Records critical errors, such as a task crash or an interface down.
1 — Records warning messages, such as incorrect address, incorrect protocol, and
failed checksum.
2 — Records information such as VLAN, VRID, priority, auth-type, advert-interval, and
IP address.
3 — Records the same information recorded in level 2, with more detail.
4 — Displays a dump of each packet.
5 — No additional information recorded.
vlan name Specifies a VLAN name.