92 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Accessing the Switch
enable license
enable license [basic_L3 | advanced_L3 | full_L3 ] <license_key>
Description
Enables a particular software feature license.
Syntax Description
Default
N/A.
Usage Guidelines
Specify
license_key
as an integer.
The
unconfigure switch all
command does not clear licensing information. This feature cannot be
disabled after the license has been enabled on the switch.
Depending on the software version running on your switch, and the type of switch you have, only the
license parameters applicable to your software or switch can be used.
To view the type of license you are currently running on the switch, use the
show switch
command.
The license key number is not displayed, but the type of license is displayed in the
show switch
output. The type of license is displayed after the system name, system location, system contact, and
system MAC address.
Example
The following command enables a full L3 license on the switch:
enable license fullL3
History
This command was first available in ExtremeWare 4.0.
Platform Availability
This command is available on all platforms.
basic_L3 Specifies a basic L3 license. (4.x only)
advanced_L3 Specifies an advanced L3 license. (4.x only)
full_L3 Specifies a full L3 license. (6.0, 6.1 and higher)
license_key Specifies your software license key.
To Next Page
Loading...