2020 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
configure wireless ports interface ap-scan updated-trap
configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
updated-trap [on |
off]
Description
Use this command to configure the access point (AP) scan to send an SNMP trap when information
about an AP has changed.
Syntax Description
Default
Off.
Usage Guidelines
None.
Example
The following example enables the port 20 using interface 1 to send an SNMP trap when an AP has
changed.
configure wireless ports 20 interface 1 ap-scan updated-trap on
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
on Specifies to send an SNMP trap when an AP has changed.
off Specifies not to send an SNMP trap when an AP has changed.
To Next Page
Loading...
Need help?
General
