2154 ExtremeWare Software 7.3.0 Command Reference Guide
Troubleshooting Commands
configure debug-trace health-check
configure debug-trace health-check [<debug level> | {filter [real |
virtual] <ip address> [ftp | http | https | imap4 | ldap | nntp | pop3 |
smtp | socks | telnet | tftp | web | wildcard | www | <tcp port number>]}]
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
filter Specifies a filter.
real Specifies a real IP address.
virtual Specifies a virtual IP address.
ip address Specifies the IP address.
ftp Specifies FTP messages.
http Specifies HTTP messages.
https Specifies HTTPS messages.
imap4 Specifies IMAP4 messages.
ldap Specifies LDAP messages.
nntp Specifies NNTP messages.
pop3 Specifies POP3 messages.
smtp Specifies SMTP messages.
socks Specifies SOCKS messages.
telnet Specifies Telnet messages.
tftp Specifies TFTP messages.
web Specifies HTTP messages.
wildcard Specifies messages from all services.
www Specifies HTTP messages.
debug level Specifies a debug level:
0 — Records unable to initialize or add a health check due to unavailable internal
resources (memory, tasks, sockets, timers, or queues).
1 — Records resources becoming active or inactive, unexpected code states, and
internal resources unavailable.
2 — Records resources added to or removed from health-check, configuration
parameters updated, and individual health-check activity.
3 — Records more verbose health-check activity and debug messages.
4 — No additional information recorded.
5 — No additional information recorded.
To Next Page
Loading...
Need help?
General
