Extreme Networks ExtremeWare - Enable Wireless Ports Interface Client-History

enable wireless ports interface client-history
ExtremeWare Software 7.3.0 Command Reference Guide 2057
enable wireless ports interface client-history
enable wireless ports [portlist | all] interface [1 | 2] client-history
Description
Sets the Altitude 300 to log client historical information.
Syntax Description
Default
Disable.
Usage Guidelines
Use this command to get the detail status about each associated client.
Example
The following example sets port 1:23 and interface 1 to keep historical information:
enable wireless ports 1:23 interface 1 client-history
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.